Need help?Do you have a question about the Zeta Alarm Systems Simplicity Plus 252 and is the answer not in the manual?
Guidelines for installing the fire alarm control panel, including earthing and placement.
Details about battery type, voltage, and safety precautions when handling.
Recommendations for mounting the control panel and general wiring standards.
Specific recommendations for panel placement, height, and environment.
Guidance on suitable fire-resisting cable types and adherence to BS standards.
Instructions for connecting the mains supply, including fused spur and isolation.
General guidelines for wiring various Zeta addressable products.
Instructions on setting device addresses using the rear dip switch.
Steps to configure loops from a blank or previously configured panel.
Procedure to verify loop configuration and check device counts.
How to add descriptive labels to devices for easier identification.
Selecting between Original Zeta and Fyreye Mk II protocols for addressable devices.
How to view the status, type, and label of individual loop devices.
How the panel displays fire alarm events, including first/last zone and device details.
How to disable entire zones or loop sounders for maintenance.
Step-by-step guide to disabling zones or sounders.
How to disable individual devices like detectors or call points.
Steps to program a zone for testing detectors.
Steps to program sounder circuits for testing.
Troubleshooting loop issues like double addresses or missing devices.
Identifying and resolving issues where multiple devices share the same address.
Identifying and troubleshooting loop faults like breaks or short circuits.
General| Number of Zones | 2 |
|---|---|
| Standards | EN54-2, EN54-4 |
| Zones | 2 |
| Number of Sounders | 2 |
| Power Supply | 230V AC, 50Hz |
To Next Page
