Motherboard Technical Specification
Page 34
Green PC Monitor Power State This option specifies the power state that the green PC-compliant
video monitor enters when AMIBIOS places it in a power saving state after
the specified period of display inactivity has expired. The settings are Off,
Standby, Suspend, or Disabled. The Optimal and Fail-Safe default settings
are Disabled.
Video Power Down Mode This option specifies the power state that the video subsystem enters
when AMIBIOS places it in a power saving state after the specified
period of display inactivity has expired. The settings are Standby,
Suspend or Disabled. The Optimal and Fail-Safe default settings are
Disabled.
Hard Disk Power Down Mode This option specifies the power conserving state that the hard disk
drive enters after the specified period of hard drive inactivity has
expired. The settings are Disabled, Standby, or Suspend. The Optimal
and Fail-Safe default settings are Disabled.
Hard Disk Timeout This option specifies the length of a period of hard disk drive inactivity. When
this length of time expires, the computer enters power-conserving state specified
in the Hard Disk Power Down Mode option (see the previous page). The
settings are Disabled, 1 min. (minute), 2 min, 3 min., 4 min., 5 min., 6 min, 7
min., 8 min., 9 min., 10 min., 11 min., 12 min., 13 min., 14 min, and 15 min. The
Optimal and Fail-Safe default settings are Disabled.
Standby/Suspend Timer Unit This option specifies the unit of time used for the Standby and Suspend
timeout periods. The settings are 4 msec, 4 sec, 32 sec, or 4 min. The
Optimal and Fail-Safe default settings are 4 min.
Standby Timeout This option specifies the length of a period of system inactivity while in Full power
on state. When this length of time expires, the computer enters Standby power state.
The settings are Disabled, 4 msec, 8 msec, 12 msec, 16 msec, up to 508 msec, in
increments of 4 msec. The Optimal and Fail-Safe default settings are Disabled.
Suspend Timeout This option specifies the length of a period of system inactivity while in Standby
state. When this length of time expires, the computer enters Suspend power state.
The settings are Disabled, 4 msec, 8 msec, 12 msec, 16 msec, up to 508 msec, in
increments of 4 msec. The Optimal and Fail-Safe default settings are Disabled.
Slow Clock Ratio This option specifies the speed at which the system clock runs in the Standby Mode
power saving state. The settings are expressed as a percentage between the normal
CPU clock speed and the CPU clock speed when the computer is in the power-
conserving state. The settings are 0-12.5%, 12.5-25%, 25-37.5%, 37.5-50%, 50-
62.5%, 62.5-75%, or 75-87.5%. The Optimal and Fail-Safe default settings are 50-
62.5%.
To Next Page
Loading...