Motherboard Technical Specification
Page 35
Display Activity When set to Monitor, this option enables event monitoring on the video display. If set
to Monitor and the computer is in a power saving state, AMIBIOS watches for
display activity. The computer enters the Full On state if any activity occurs.
AMIBIOS reloads the Standby and Suspend timeout timers if display activity occurs.
The settings are Monitor or Ignore. The Optimal and Fail-Safe default settings are
Ignore.
Device 6 (Serial Port 1)
Device 7 (Serial Port 2)
Device 8 (Parallel Port)
Device 5 (Floppy Disk)
Device 0 (Primary Master IDE)
Device 1 (Primary Salve IDE)
Device 2 (Secondary Master IDE)
Device 3 (Secondary Slave IDE) When set to Monitor, these options enable event monitoring on the
specified hardware interrupt request line. If set to Monitor and the
computer is in a power saving state, AMIBIOS watches for activity
on the specified IRQ line. The computer enters the Full On state if
any activity occurs. AMIBIOS reloads the Standby and Suspend
timeout timers if activity occurs on the specified IRQ line.
The settings for each of these options are Monitor or Ignore. The
Optimal and Fail-Safe default settings are Ignore.
To Next Page
Loading...