801314 v3.05 09.20 HT BC Commercial Instructions Page 7 of 28
Important Safety Instructions
WARNINGS
1. The HydroTap Command Centre must be earthed. The resistance of the
earth connection from each exposed metal part must be less than 1 ohm.
2. All Installation and service work must be completed by trained and
suitably qualified Tradespeople. Faulty operation due to unqualified
persons working on this product, or any other Zip product may void
warranty coverage.
3. Plumbing and electrical connections must be made in accordance with
local regulations and relevant standards. In Australia and New Zealand:
Plumbing standard AS/NZS 3500 & Electrical Wiring Rules AS/NZS 3000.
4. This HydroTap product is rated for 230V 50Hz AC operation.
5. This Command Centre must be installed with adequate clearances
of 50mm on all sides, and 200mm above, to allow for air circulation.
Additional means of ventilation is critical if the vent kit, as supplied, cannot
be fitted.
6. Flush water supply lines before any plumbing connections are made, to
prevent sediment from affecting operation.
7. The Command Centre must not be located near, or cleaned with water
jets.
8. This product is designed for indoor use and must not be installed outdoors
or exposed to the elements of nature.
9. For safe operation, the HydroTap is designed to be installed,
commissioned and used within 48 hours. Should the HydroTap not be
required for an extended period of time (72 hours or more), do not fill and
commission the HydroTap until ready for first use.
10. For water taste and quality reasons, following any non-use period of more
than 72 hours, Zip recommends to perform a system flush. Failure to flush
the system may affect water quality.
11. Due to the process of continuous improvement, Zip Water reserves the
right to change details mentioned in this manual, without notice.
!
To Next Page
Loading...
