Step 1：Place the fingerprint machine properly and power up
machine.
Step 2: Enroll user, register fingerprint and password, and assign
privilege to user.
Step 3: verify user by the registered fingerprint and password.
Step3: Configure the communication parameter; download the staff
information to software using the U flash disk or one of three
communications which is used to connect with the computer.
Step 5：Revise the staff’s information in the staff maintenances item
of software, connect the equipment with PC again and upload the
staff information to the equipment. At this time when the
fingerprint machine track staff’s Time & Attendance log , his/her
name will be display on the screen.
Step 6：Check the fingerprint machine time, and make sure
whether it is correct, after completing setting up, then start to track
employee’s attendance.
Step7：At the end of the month the downloaded attendance log to
software will be calculated.
The equipment is at the standby status.
To Next Page
Loading...