iFace Series Installation Guide
13
3.2.4 Door lock connection
The way of installing door lock depends on the type of lock and
local condition. Internal resistor which comes from long distance
transfer should be taken into consideration when selecting the
cable of electric power. The door lock should be installed reliable
and stable .Ensure the wiring is correct. For the strike lock and
electromagnetic lock, you should pay attention to positive and
negative terminal connection. The unused bare end of wire should
be cut off and use insulating tape to wrap it. The delay time of
strike lock is adjustable according to different conditions.
z When the Access Control System connected with Electric lock,
to prevent the self-inductance EMF to affect the access control
system, you need to parallel one FR107 diode (do not reverse the
polarity) . Please use the equipped diode in the package.
Select electric lock ：it is better to use strike lock for the two
–direction opening glass door (both open to inside or outside
direction ) ,for the single opening wood door in company internal ,
we recommend to use magnetic lock, the magnetic lock also be
called as electric magnetic lock,. The magnetic lock is more
reliable than the strike lock, but the strike lock is much safer than
the magnetic lock. In the small living community, it is better to use
strike lock and magnetic force lock. The electric control lock gives
out higher noise; the electric control lock is commonly used to
building communication. Now there is a soundless electric control
lock which is able to be applied. Please pay attention, the lock is
made of iron and easy rust, so you must beware of not exposing it
To Next Page
Loading...
Need help?
General
