ZKTeco iFace Series User Manual

iFace Series Installation Guide
24
5. Others
5.1 Reset
Due to operation error or other accidence, which leads the
machine not to work, you can restart machine through reset key。
① take a small tool which diameter is no more than 2mm。
② find reset mark of “res” on the left small hole on the bottom of
device, see following figure。
③Use the tool plug into the hole refer to the picture on right , then
plug out. The machine is able to restar。
Reset

ZKTeco iFace Series Specifications

General

Fingerprint Capacity	500-3000
Log Capacity	100000
Communication	TCP/IP, USB
Operating Temperature	0 °C- 45 °C
Operating Humidity	20%-80%
Verification Speed	<1 second
Weight	Varies by model
Face Capacity	700 (Up to 3, 000)