Zodiac Ei2 Expert - Boost Mode Operation; Low Mode Operation; Setting the Time

10
3.2.1 Chlorine produc on ac vated
When chlorine produc on starts, the "Start..." message is displayed on screen for about 6 seconds. "CHLORINATION" is
then displayed, indica ng that the appliance is producing chlorine.
3.2.2 "BOOST" mode: chlorine produc on increased to 100 % for 24 h
In certain cases the pool may need higher than normal chlorina on (stormy weather, high number of bathers, etc.).
"BOOST" mode is used to increase chlorine level quickly.
• Press bu ons
and simultaneously: "BOOST" is displayed on the screen and 100 % chlorine produc on
starts.
• To stop "BOOST" mode, press
.
When "BOOST" mode is ac vated, the rated chlorine produc on se ngs are temporarily overridden and the
Ei² Expert chlorinator will operate for a total of 24 hours at 100 % chlorine produc on. The number of days will
therefore depend on the Ei² Expert opera ng  mes (see “3.2.5 “SUMMER” and “WINTER” modes and se ng
the “Timers””).
3.2.3 "LOW" mode: chlorine produc on reduced to 10 % if the pool is covered
If the pool has a covering system (shelter, shu er, cover, etc.), "LOW" mode is designed to adapt chlorine produc on to
situa ons where the pool is covered (lower needs). Its purpose is to limit chlorine produc on to 10%.
If chlorina on is set to 0% when closing the shu er, "LOW" mode will keep the 0% se ng.
This mode is also called "Shu er" mode.
Manual ac va on (shelter, cover, etc.):
• Press bu ons
and simultaneously: "LOW" is displayed on the screen and chlorine produc on is reduced
to 10 %.
• To stop "LOW" mode, press
.
Automa c ac va on (compa ble with an electric roller shu er):
• Make sure the cover is compa ble and connected to the chlorinator (see “2.5.2 Connec on to an electric roller shu er”).
• "LOW" mode will automa cally be ac vated when the shu er is closed.
• "LOW" mode will stop as soon as the shu er is completely open.
3.2.4 Se ng the  me
The Ei² Expert chlorinator is   ed with an internal memory. When the appliance is  rst switched on, it is
important to leave it powered on con nuously for at least 24 hours in order to ini ally charge the accumulator
(permanent separate power supply or  ltering on permanently). Once charged, the accumulator has several
weeks of autonomy in the event of a power failure.
The  me is displayed in 24-hour format.
• Switch on the appliance and wait un l the screen start-up sequence is  nished.
• Press the bu on to access the user menu, the minutes will start to fl ash.
• Use the and bu ons to set the minutes, then press to save.
• Use the and bu ons to set the hours, then press to save.
• Press the bu on to return to the home screen.