ZOLL PD 2000 - Page 51

CHECKOUT. PROCEDURES
SECTION 8. MFE TESTS
Note: Perform steps 8.2 and 8.3 on PD 2000 and D 2000 units only.
Perform this Action: Look for: Circle the Result
81 Install Multi-Function "ELECTRODES" message YES NO
Cable. appears on display.
8.2 MFC should be installed "ELEC. PADS OFF" and YES NO
but not connected to the "ANALYSIS HALTED"
test connector. Press messages appear on display.
ANALYZE button.
83 Connect MFC to ZOLL
S-3000 simulator.
Press ANALYZE button "NO SHOCK ADVISED" YES NO
for Normal Sinus rhythm. | message appears on CRT.
Press ANALYZE button | "SHOCK ADVISED" YES NO
for Ventricular Fibrillation | message appears on CRT.
rhythm. |
Press ANALYZE button | "NO SHOCK ADVISED" YES NO
for Asystole rhythm. message appears on CRT.
84 Set to energy level 2] and "ELECTRODES OFF" YES NO
charge. Attempt discharge | message appears on CRT.
(without test connector).
8.5 Plug MFC into test Unit discharges. YES NO
connector, charge to 2] and
discharge.
8.6 Charge to 100] and "TEST OK" message appears | YES NO
discharge. on CRT.
“TEST OK" message on strip. YES NO
SECTION 9. REAL TIME CLOCK TEST
Perform this Action: Look for: Circle the Result
9.1 Correct date and time Correct date and time YES NO
displayed. displayed.
1-39