ZOLL PD 2000 - Initialize Test

SERVICE MANUAL
1. INITIALIZE TEST
The Initialize Test verifies that the PD™ 1400-series unit is:
« electrically connected to a ZOLL PD™ 4410 battery or
PowerCharger™
+ LEDs, sensors, and message codes are operating
+ recorder paper is properly installed
+ date and time display is shown
1.1 INITIALIZATION
' (Paddles must be installed in the unit.)
e Turn SELECTOR SWITCH to MONITOR ON.
+ Listen for 4 beep audible tone.
PADDLE CHARGE LED goes on and then off.
"READY" message displayed for 4 seconds.
Mark the Checkout Procedure Data Sheet.
1.2 RECORDER CHECK
+ Make sure there is no paper in the paper well.
e Press the RECORDER ON-OFF button.
“NO PAPER" message is displayed.
Mark the Checkout Procedure Data Sheet.
+ Put a roll of paper in the paper well.
« Press RECORDER ON-OFF button.
"NO PAPER" message is removed and recorder operates correctly.
Mark the Checkout Procedure Data Sheet.
1.3 DATE AND TIME CHECK
+ Press the RECORDER ON-OFF button to get a print-out on the
recorder paper of the date and time.
Verify that the date and time are correct.
1.4 SET THE CORRECT DATE AND TIME. (ONLY IF NECESSARY)
Unit should be turned off.
« Press and hold the ALARM SET button while turning the unit to
MONITOR ON.
+ Use the ALARM SET up arrow and down arrow buttons to set the
DATE. (Refer to the Operator's Manual.)
e Press ALARM SET again to input that date.
Repeat the last two steps for the MONTH, YEAR, and TIME of DAY.
+ Press ALARM SET again. The "MONITOR" message is displayed.
+ Turn off the unit.
1-4