ZONEMASTER MAXIPOINT V2 - Table of Contents

ZONEMASTER MAXIPOINT V2 DAMPER CONTROL SYSTEM - Installation Manual
1
1) Application 2
2) Features 2
3) Components 3
4) Configuration 4
5) Pre-Installation 6
6) Component Installation 7
7) Recommended Commissioning Procedure 10
7.1 Initiating and Exiting Setting Process 10
7.2 Setting Parameters 10
1) Touchpad Address 10
2) Number of Groups in the System 11
3) Supply Air Safety High & Low Limits 11
4) Spill/Bypass Mode 12
5) Turbo Group 14
7.3 Grouping Zones 15
7.4 Balancing Zones 16
7.5 Naming Groups 17
7.6 Enabling/Disabling Service Reminder 18
7.7 Enabling/Disabling Temperature Display 19
7.8 Programming On/Off Mode 20
1) Set Clock and Day 20
2) Adjust Program Time 21
3) Select Program for a Group 22
7.9 Testing Damper On/Off 22
7.10 Wiring Diagram for MaxiPoint V2 23
TABLE OF CONTENTS
Liability
Please read the instructions before installing this Zonemaster Zoning Control System.
Polyaire Pty Ltd does not accept any responsibility for loss or damage that may occur
as a result of the incorrect installation of this Zoning Control System.