30
Chapter 5 Client+AP Mode
5.1 Setup Wizard
1. Select Client+AP on top banner and then select Setup Wizard on the left list.
Click Next to continue.
2. Configure Client Settings, and then click Next.
SSID: Input the SSID of the AP you want to connect. Or click Scan button to
select an AP you want to connect.
MAC: Input the MAC address of the AP you want to connect. Or click Scan
button to select an AP you want to connect.
Channel: Select the channel used for wireless communication from drop-down
list. Available channel numbers are 1 to 13 for European countries, 1 to 11 for
USA.
Security Mode: Select from None, WEP, WPA-PSK, WPA2-PSK.
Pass Phrase: Enter the key which must have 8-63 ASCII characters.
To Next Page
Loading...
