Zoom 8080 - Using the USER FUNCTION Switch to Call up a Bank or Patch

■
38
Advanced Operation
Using the USER FUNCTION switch to call up a bank or patch
In Play mode, press
the
three times to call up
the page shown
below.
UTILITY/PAGE key
1
Use 2 to
set the "USER
FUNCTION=" item to
"BANK" or "PATCH".
"BANK"
"PATCH"
Data entry knob
2
If "BANK" was
selected, use
3 to set
the desired bank
number in the "BNK="
item.
Data entry knob
3
CONTROL
PEDAL
CONTROL
PEDAL
CONTROL
SWITCH
DECREASE
–(TAP/HOLD)
INCREASE
BANK
MAX
CONTROL
SWITCH
INDICATOR
1/2
MIN
BLINK
(DLY:TAP)
COMP EFF1 DIST EQ EFF2 EFF3 DLY REV TOTAL
EDIT
EXIT
TYPE
–+
PRESENCE OUTPUT
GROUP
COMPARE
FINE TUNE
Super
ADVANCED GUITAR EFFECTS PROCESSOR
STORE
(EXECUTE)
34
12
MAXMIN
MAXMINMAXMIN
MAXMIN
UTILITY
PAGE
USER
FUNCTION
2, 3, 3'
5
4
1
Display
STORE/EXECUTE key
STORE
(EXECUTE)
USER FUNCTION switch
USER
FUNCTION
MAXMIN
Data entry knobs 1-4
UTILITY
PAGE
UTILITY/PAGE key
USER FUNCTION=PRESET
3
USER FUNCTION= BANK
3 BNK=U9
The USER FUNCTION switch can be used to call up a predefined bank or patch during a performance. This is
convenient for example for frequently needed patches in a song. To do this, the following steps are required.
• In Utility mode, set the USER FUNCTION switch parameter to "BANK" (bank number) or
"PATCH" (patch number).
• In Utility mode, set the predefined bank number or patch number.
USER FUNCTION= BANK
3 BNK=U0
USER FUNCTION= PATCH
3 PAT=U01