Zoom 8080 - CMP (Compressor) Module

This module provides compression of the input signal to allow sustain effects without overload and to make the sound more
uniform.
A standard compressor with natural-sounding sustain.
Recreates a compressor type highly popular among fusion guitarists in the seventies and eighties.
The limiter serves to keep the level below a certain threshold, creating a more uniform sound.
LIM: Limiter
VCMP: Vintage Compressor 2
CMP: Compressor 1
47
■
Effect Types and Parameters
COMP EFF1 DIST EQ EFF2 EFF3 DLY REV TOTAL
CMP (Compressor) Module
For modules where "RTM → " is being shown, the RTM parameter cannot be changed.
NO
✎
UTILITY
PAGE
CMP SNS= ATK=
EQ= LoC=
CMP
RTMå DIR=
34
12
MAXMIN
MAXMINMAXMIN
MAXMIN
qw
er
34
12
MAXMIN
MAXMINMAXMIN
MAXMIN
ty
PAGE 1
PAGE 2
qw
er
ty
q SNS (Sensitivity) Sets the depth of the compression effect. 1 – 50
w ATK (Attack) Sets the speed with which compression responds
to picking. 0 – 10
e EQ (EQ) Sets the compressor tone control. -7 – +7
r LoC (Low-Cut) Controls the low-cut filter. off, on
t RTM (RTM Destination) Shows which RTM parameter is being controlled. SNS
y DIR (RTM Direction) Sets the RTM direction. NML, INV
Parameters Comment Values
UTILITY
PAGE
LIM THR= REL=
EQ= LoC=
LIM
RTMå DIR=
34
12
MAXMIN
MAXMINMAXMIN
MAXMIN
qw
er
34
12
MAXMIN
MAXMINMAXMIN
MAXMIN
ty
PAGE 1
PAGE 2
qw
er
ty
q THR (Threshold) Sets the point where the limiter takes effect. 1 – 50
w REL (Release) Sets the time required for the level to return to
the original value after falling below the threshold. 0 – 10
e EQ (EQ) Sets the limiter tone control. - 7 – +7
r LoC (Low-Cut) Controls the low-cut filter. off, on
t RTM (RTM Destination) Shows which RTM parameter is being controlled. THR
y DIR (RTM Direction) Sets the RTM direction. NML, INV
Parameters Comment Values
UTILITY
PAGE
VCMP SNS= VOL=
VCMP
RTMå DIR=
34
12
MAXMIN
MAXMINMAXMIN
MAXMIN
qw
34
12
MAXMIN
MAXMINMAXMIN
MAXMIN
er
PAGE 1
PAGE 2
qw
er
q SNS (Sensitivity) Sets the depth of the compression effect. 1 – 50
w VOL (Volume) Sets the output level. 1 – 10
e RTM (RTM Destination) Shows which RTM parameter is being controlled. SNS
r DIR (RTM Direction) Sets the RTM direction. NML, INV
Parameters Comment Values