-8 -
10. ANALOG-MUTE check
Press the [STORE/SWAP] key (SW16).
Make sure that the [STORE/SWAP] key lights red, and LCD is displayed [STORE/SWAP
ANALOG MUTE].
The 7segment LED turns [on] and [oF] by pressing the [STORE/SWAP] key.
When the 7segment LED turns on, sound from [PHONE] jack, [L/MONO] jack, [R] jack, and
[SEND] jack are extremely low.
*Make sure that there is no defect on the sound (abnormal noise .etc)
11. USB-MUTE (SW) check
Press the [EXIT] key (SW19)
Make sure that the [EXIT] key lights red, and LCD is displayed [EXIT USB MUTE].
The 7segment LED turns [on] and [oF] by pressing the [EXIT] key.
*Make sure that there is no defect on the sound (abnormal noise .etc)
12. DIRECT-MUTE check
Press the [PEDAL2 SETTING] key (SW20).
Make sure that the [PEDAL2 SETTING] key lights red, LCD is displayed [PEDAL2 SETTING
DIRECT MUTE].
The 7segment LED turns [on] and [oF] by pressing the [STORE/SWAP] key.
When the 7segment LED turns on, output sound from [PHONE] jack is lower than
ANALOG-MUTE.
*The output sound is smaller than ANALOG-MUTE, during DIRECT-MUTE on.
*The output sound from [SEND] jack doesn’t change.
*Make sure that there is no defect on the sound (abnormal noise .etc)
13. SW/LED check
When press the key in the following table2, the pressed Key lights green.
Make sure that the indications [green -> red -> orange -> light off -> green -> red …] appear on
the press the key in the following table when it pressed repeatedly.
* Only [COMP] key (SW1), below all switches turn on if pressing that key.
Table2. SW LCD display
SW LCD
[COMP](SW1) COMP
[WAH/EFX](SW2) WAH/EFX
EXT LOOP (SW614) EXT LOOP
[ZNR](SW6) ZNR
[PRE-AMP](SW9) PRE-AMP
[EQ](SW4) EQ
[CABINET](SW7) CABINET
[MOD/EFX2](SW10) MOD/SFX
[DELAY](SW8) DELAY
[REBERB](SW11) REVERB
[TOTAL/FUNCTION](SW3) TOTAL/EFX CHAIN
To Next Page
Loading...
