3 Preparation Work
4.
Click OK.
After the IP address of the computer is set, you can run the Ping command to ping the
IP address 192.168.1.1. If the ping operation is successful, it indicates that the TCP/IP
configuration is correct and the computer is properly connected to the ZTE H1600.
3.2
Login
The ZTE H1600 provides a Web-based configuration and management system. You can
enter a specified IP address in the address bar of Internet explorer to access the sys-
tem.
A computer is directly connected to the LAN port of ZTE H1600, and their IP addresses
are in the same network segment.
1.
Open Internet explorer, and enter http://192.168.1.1 (default maintenance IP address
of the ZTE H1600) in the address field. Press the Enter key. The login page is dis-
played, see Figure 3-1.
Figure 3-1 Login Page
2.
Enter your username and password and click Login. The configuration page is dis-
played, see Figure 3-2.
To Next Page
Loading...
