Zte H1600 - Configure the FTP

SJ-20210621164956-008 | 2022-09-01(R1.3)
65
5 Configure the Local Network
Parameter
Description
Destination Port
Destination port number of the matching packets.
Source MAC Address
MAC address of the source device that sends the matching
packets.
3. Click Apply button to apply the changes.
5.5 Configure the FTP
The section describes how to configure FTP. FTP provides the parameters of FTP con-
figuration features.
Before configuring FTP application, make sure a USB storage device is connected to
open the ZTE H1600 device.
1. On the main page of the ZTE H1600, select Local Network > FTP to open the FTP
page, see Figure 5-25.
Figure 5-25 FTP
2. Table 5-13 lists the FTP parameters.
Table 5-13 FTP parameters
Parameter
Description
Server
Click On to enable the FTP server function.
Click Off to disable the FTP server function.
Username/Password
It is valid only if the FTP security function is enabled.
3. Click Apply button to apply the changes.
5.6 Configure the UPnP
The procedure provides the parameters of UPnP configuration features.
Prerequisite
Steps