SJ-20210621164956-008 | 2022-09-01(R1.3)
ZTE H1600 Maintenance Management Guide
6.2
Configure the SIP Accounts
This procedure describes how to configure basic parameters of the VoIP service, includ-
ing SIP account, authorization username and password.
1.
On the main page of the ZTE H1600 device, select VoIP > Telephone Number to
open the SIP Account page, see Figure 6-2.
Figure 6-2 SIP Accounts Page
2.
Set the parameters. Table 6-1 describes the SIP account parameters .
Table 6-1 Description of the SIP Account Parameters
Click On to enable the account service.
Registered name of a SIP subscriber. Normally, it is the phone number
of the subscriber.
Username for authentication by the SoftSwitch system, which must be
the same as that configured in the SoftSwitch system.
Password for VoIP service authentication by the SoftSwitch system,
which must be the same as that configured in the SoftSwitch system.
3.
Click Apply button to apply the changes.
6.3
Configure the VoIP Service
This procedure describes how to configure additional services for the SIP-based VoIP
service on the ZTE H1600.
To Next Page
Loading...
