Zte ZXR10 ZSR V2 - Chapter 5 RIPng Configuration

Chapter5
CommandPrivilegeLevel
Classication
TableofContents
CommandPrivilegeLevelOverview...........................................................................5-1
ConguringCommandPrivilege................................................................................
5-1
CommandPrivilegeLevelCongurationExample......................................................5-2
5.1CommandPrivilegeLevelOverview
TheZXR10ZSRV2supportsthecommandprivilegelevelfunction.Commandprivilege
levelmanagementisusedtocongurecommandprivileges.Userscanruntheprivilege
commandtoconguretheprivilegeofacommand.
Commandprivilegelevelsrangefromlevel1tolevel15.Differentcommandscanbe
conguredwithdifferentprivilegelevels.Afterauserlogsin,acommandviewisdisplayed
accordingtotheuser'sprivilegelevel.Therefore,theusercannotruncommandswhose
privilegelevelsarehigherthantheuser'slevel.Userswiththehighestlevel(thatis,
administratorswithlevel15)cansetprivilegelevelsforcommands.
5.2ConguringCommandPrivilege
Thisproceduredescribeshowtocongurecommandprivileges.
Steps
1.Congurecommandprivileges.
CommandFunction
ZXR10(config)#privilege<logic-mode>[all]level{<level>|
default}<command-keywords>
Conguresacommandprivilege
level.
ZXR10(config)#noprivilege<logic-mode>[all]node
<command-keywords>
Restoresthedefaultcommand
privilegelevel.
[all]:allcommandsbeginningwiththiskeyword.
level<level>:privilegelevel,range:1–15
default:defaultcommandprivilegelevel.
<command-keywords>:commandkeywords,range:1–200characters.
5-1
SJ-20140504150128-007|2014-05-10(R1.0)ZTEProprietaryandCondential