ZyXEL AG-225H v2 User’s Guide
Chapter 2 Tutorial 31
2.3 Configuring the AG-225H v2 as an AP
In access point mode, your AG-225H v2 allows you to set up your wireless network without
using a dedicated AP. Refer to Section 1.2.3 on page 21 and Chapter 5 on page 57 for more
information.
Note: With WZC, you cannot use the AG-225H v2 as an access point.
After you install the ZyXEL utility and then insert the AG-225H v2, follow the steps below to
set up your AG-225H v2 as an AP.
1 Select AP Mode in any utility screen and wait for five seconds. The screen changes and
displays as follows. Under Status, you can view the current settings on the AG-225H v2.
In the Association List, you can see if any wireless clients have connected to your AG-
225H v2.
Figure 19 ZyXEL Utility: AP: Link Info
2 If you want to change the SSID and enable wireless security for your AG-225H v2, click
the Configuration tab and refer to Section 5.3 on page 59 for detailed field descriptions.
Note: Only WEP security is available when the AG-225H v2 is in AP mode
To Next Page
Loading...
