ZyXEL Communications AG-225H - Appendix B; Access Point Mode Setup Example; Figure 46 Windows 2000: Start

ZyXEL AG-225H v2 User’s Guide
Appendix B 71
APPENDIX B
Access Point Mode Setup Example
This example uses the network sharing feature in Windows 2000 to bridge the wired and
wireless network when you set the AG-225H v2 in access point (AP) mode.
Refer to Chapter 5 on page 57 for setup methods and requirements.
Steps may vary depending on your Windows version.
Configuring the Computer on Which You Install the AG-225H
v2
1 Refer to Section 1.2.3 on page 21 to set the AG-225H v2 to operate in AP mode.
2 Click Start, Settings, Network and Dial-up Connections (or click Start, Settings,
Control Panel and double-click Network and Dial-up Connections).
Figure 46 Windows 2000: Start
3 Right-click on the icon for your wired Ethernet adapter and click Properties.