ZyXEL AG-225H v2 User’s Guide
Chapter 5 Access Point Mode Configuration 57
CHAPTER 5
Access Point Mode
Configuration
This chapter shows you how to configure your AG-225H v2 in access point mode.
5.1 Access Point Mode Introduction
To set your AG-225H v2 to access point (AP) mode, select AP Mode in any utility screen
(refer to Section 1.2.3 on page 21).
Access point mode allows you to set up your wireless networks without using a dedicated AP.
5.1.1 ZyXEL Utility Screen Summary
This section describes the ZyXEL utility screens when the AG-225H v2 is in AP mode.
Figure 39 ZyXEL Utility Menu Summary: AP Mode
The following table describes the menu.
Table 15 ZyXEL Utility Menu Summary: AP Mode
TAB DESCRIPTION
AP Mode
Link Info Use this screen to see your current connection status, configuration and data rate
statistics.
Configuration Use this screen to configure wireless LAN settings.
MAC Filter Use this screen to configure which computer(s) you want access to the wireless
LAN through the AG-225H v2.
To Next Page
Loading...
