ZyXEL Communications AG-225H - Security Settings; WEP Encryption; Figure 26 Station Mode: Security Setting: WEP; Table 6 Station Mode: Security Setting: WEP

ZyXEL AG-225H v2 User’s Guide
Chapter 4 Wireless Station Mode Configuration 43
4.3.1 Security Settings
When you configure the AG-225H v2 to connect to a network with wireless security activated
and the security settings are disabled on the AG-225H v2, the screen varies according to the
encryption method used by the selected network.
4.3.1.1 WEP Encryption
Figure 26 Station Mode: Security Setting: WEP
The following table describes the labels in this screen.
Encryption This field shows whether data encryption is activated (WEP (WEP or 802.1x),
WPA, WPA-PSK, WPA2, WPA2-PSK) or inactive (DISABLE).
MAC address This field displays the MAC address of the wireless device.
Surveyed at This field displays the time when the wireless device was scanned.
Table 5 Station Mode: Site Survey (continued)
LABEL DESCRIPTION
Table 6 Station Mode: Security Setting: WEP
LABEL DESCRIPTION
Security Settings
WEP Select 64 Bits, 128 Bits or 256 Bits to activate WEP encryption and then fill in the
related fields.
Authentication
Type
Select an authentication method. Choices are Open or Shared. Refer to Section
3.2.3.1.2 on page 35 for more information.
Pass Phrase Enter a passphrase of up to 63 case-sensitive printable characters. As you enter
the passphrase, the AG-225H v2 automatically generates four different WEP keys
and displays it in the key field below. Refer to Section 3.2.3.1.1 on page 35 for
more information.
At the time of writing, you cannot use the passphrase function to generate 256-bit
WEP keys.
Transmit Key Select a default WEP key to use for data encryption. The key displays in the field
below.