ZyXEL Communications AG-225H - Figure 33 Station Mode: Profile: Select Wireless Mode and Channel

ZyXEL AG-225H v2 User’s Guide
Chapter 4 Wireless Station Mode Configuration 51
2 If you select the Infrastructure network type in the previous screen, skip to step 3. If you
select the Ad-Hoc network type in the previous screen, a screen displays as follows.
Select a wireless frequency and channel number and click Next to continue.
Note: To associate to an ad-hoc network, you must use the same channel and
wireless frequency as the peer computer.
Figure 33 Station Mode: Profile: Select Wireless Mode and Channel
Scan Info This table displays the information of the available wireless networks within the
transmission range.
, denotes that the wireless device is in infrastructure mode and the wireless
security is activated.
, denotes that the wireless device is in infrastructure mode but the wireless
security is deactivated.
or denotes that the wireless device is in Ad-Hoc mode and the wireless
security is activated.
. denotes that the wireless device is in Ad-Hoc mode but the wireless security
is deactivated.
SSID This field displays the SSID (Service Set IDentifier) of each AP or peer device.
Scan Click Scan to search for available wireless devices within transmission range.
Select Select an available wireless device in the table and click Select to add it to this
profile.
Whenever you activate this profile, the AG-225H v2 associates to the selected
wireless network only.
Table 12 Station Mode: Profile: Add a New Profile (continued)
LABEL DESCRIPTION