Chapter 7 Wireless
LTE Series User’s Guide
112
7.7 WMM
Use this screen to enable WiFi MultiMedia (WMM) and WMM Automatic Power Save (APSD) in wireless
networks for multimedia applications. WMM enhances data transmission quality, while APSD improves
power management of wireless clients. This allows delay-sensitive applications, such as voice and
videos, to run more smoothly.
Click Network Setting > Wireless > WMM to display the following screen.
Figure 78 Network Setting > Wireless > WMM
Note: WMM cannot be disabled if 802.11 mode includes 802.11n or 802.11ac.
Register Enter the PIN of the device that you are setting up a WPS connection with and click Register to
authenticate and add the WiFi device to your WiFi network.
You can find the PIN either on the outside of the device, or by checking the device’s settings.
Note: You must also activate WPS on that device within two minutes to have it
present its PIN to the Zyxel Device.
Method 3 Use this section to set up a WPS WiFi network by entering the PIN of the Zyxel Device into the
client. Click this switch to make it turn blue. Click Apply to activate WPS method 3 on the Zyxel
Device.
Release
Configuration
The default WPS status is configured.
Click this button to remove all configured WiFi and WiFi security settings for WPS connections on
the Zyxel Device.
Generate
New PIN
If this method has been enabled, the PIN (Personal Identification Number) of the Zyxel Device is
shown here. Enter this PIN in the configuration utility of the device you want to connect to using
WPS.
The PIN is not necessary when you use the WPS push-button method.
Click the Generate New PIN button to have the Zyxel Device create a new PIN.
Cancel Click Cancel to restore your previously saved settings.
Apply Click Apply to save your changes.
Table 34 Network Setting > Wireless > WPS (continued)
LABEL DESCRIPTION
To Next Page
Loading...
