ZyXEL Communications LTE5388-M804 - 4.13 Configure Static Route for Routing to Another Network

Chapter 4 Tutorials
LTE Series User’s Guide
65
3 Click Static DHCP Configuration in the Static DHCP Configuration screen.
4 Select Active and type the IP address you want to assign to your device.
5 Type the MAC Address of your device to which the LTE7460 assigns the IP address and click OK.
4.13 Configure Static Route for Routing to Another
Network
In order to extend your Intranet and control traffic flowing directions, you may connect a router to the
Zyxel Device’s LAN. The router may be used to separate two area networks. This tutorial shows how to
configure a static routing rule for two network routings.
In the following figure, router R is connected to the Zyxel Device’s LAN. R connects to two networks, N1
(192.168.1.x/24) and N2 (192.168.10.x/24). If you want to send traffic from computer A (in N1 network) to