Chapter 28 TR-069 Client
LTE Series User’s Guide
254
The following table describes the fields in this screen.
Table 110 Maintenance > TR-069 Client
LABEL DESCRIPTION
CWMP Active CPE WAN Management Protocol (CWMP) enables the Zyxel Device to be remotely configured
via a WAN link. Communication between the Zyxel Device and the management server is
conducted via SOAP/HTTP(S) in the form of remote procedure calls (RPC).
Click to enable (switch turns blue) to allow the Zyxel Device to be managed by a management
server. Otherwise, click to disable (switch turns gray) to disallow the Zyxel Device to be managed
by a management server.
Inform Click to enable (switch turns blue) the Zyxel Device to send periodic inform via TR-069 on the
WAN. Otherwise, click to disable (switch turns gray).
Inform Interval Enter the time interval (in seconds) at which the Zyxel Device sends information to the auto-
configuration server.
IP Protocol Select the type of IP protocol to allow TR-069 to operate on.
ACS URL Enter the URL or IP address of the auto-configuration server.
ACS User Name Enter the TR-069 user name for authentication with the auto-configuration server.
ACS Password Enter the TR-069 password for authentication with the auto-configuration server.
WAN Interface
used by TR-069
client
Select a WAN interface through which the TR-069 traffic passes.
If you select Any_WAN, the Zyxel Device automatically passes the TR-069 traffic when any WAN
connection is up.
If you select Multi_WAN, you also need to select two or more pre-configured WAN interfaces. The
Zyxel Device automatically passes the TR-069 traffic when one of the selected WAN connections
is up.
Cellular WAN The Zyxel Device automatically passes the TR-069 traffic when cellular WAN connection is up
.
Display SOAP
messages on
serial console
Click to enable (switch turns blue) the dumping of all SOAP messages during the ACS server
communication with the CPE
.
Connection
Request
Authentication
Select this option to enable authentication when there is a connection request from the ACS.
Connection
Request User
Name
Enter the connection request user name.
When the ACS makes a connection request to the Zyxel Device, this user name is used to
authenticate the ACS.
Connection
Request
Password
Enter the connection request password.
When the ACS makes a connection request to the Zyxel Device, this password is used to
authenticate the ACS.
Connection
Request URL
This shows the connection request URL.
The ACS can use this URL to make a connection request to the Zyxel Device.
Validate ACS
Certificate
Click to enable (switch turns blue) the validation of a local certificate used by TR-069 client.
Local certificate
used by TR-069
client
You can choose a local certificate used by TR-069 client. The local certificate should be
imported in the Security > Certificates > Local Certificates screen.
Apply Click Apply to save your changes.
Cancel Click Cancel to restore the screen’s last saved settings.
To Next Page
Loading...
