Tone configuration command does not cause ADSL PHY retrain automatically. To experience the
effect of this command ADSL connection must be restarted using for example adsl connection –down
followed by adsl connection –up command.
Tone selection is not affected by adsl configure commands and has to be changed explicitly.
--normal :
Puts modem in Normal mode
--freezeReverb :
Puts modem in freeze reverb mode
--freezeMedley :
Puts modem in freeze medley mode
Options for the bert command
adsl bert [--start <seconds>] [--stop] [--show]
--start :
Starts Bit Error Rate Test (BERT)
seconds – duration of BERT test in seconds
--stop :
Stops the BERT test.
--show :
Display BERT results to stdout in the following format:
BERT Status = [NOT] RUNNING
BERT Total Time = 10 sec
BERT Elapsed Time = 10 sec
BERT Bits Tested = 0x00000000045A6380 bits
BERT Err Bits = 0x0000000000000002 bits
BERT Status indicates whether or not the BERT test is currently running. It can be used to monitor when
the BERT test is complete after it is started. The numbers of total bit tested and errorred bits are displayed
as 64 bit hexadecimal numbers.
Options for the info command
adsl info [--state] [--show] [--stats] [--SNR] [--QLN] [--Hlog] [--Hlin] [--HlinS]
[--Bits][--pbParams][--linediag][--linediag1][--reset][--vendor][--cfg]
--state :
Displays the shortest message about ADSL PHY connection state, e.g.
adsl: ADSL driver and PHY status
Status: Showtime Channel: FAST, Upstream rate = 8064 Kbps, Downstream rate = 1024 Kbps
To Next Page
Loading...
