> df
° Display the space available on the flash root file system
df /dev/mtdblock0
DHCPSERVER
NAME
dhcpserver – allow a user to configure, or show the DHCP Server data
SYNOPSIS
dhcpserver config <start IP address> <end IP address> <leased time (hour)>
dhcpserver show
dhcpserver --help
DESCRIPTION
dhcpserver is used to configure, or show the DHCP server data. This utility can:
° configure the DHCP server on the primary LAN interface.
° show the DHCP server configuration data.
° display usage.
All information is displayed to stdout. A program or shell script that calls this utility can redirect stdout to
a file and then parse the file in order to interpret the displayed output.
This command only configures the settings of the DHCP server. To enable or disable the DHCP server, use
the lan config command.
COMMANDS
config
configure the DHCP server with the given data.
Notice: the command saves the configuration data to the flash but does not take effect until the system
is rebooted.
show
show the DHCP server configuration data.
--help
display usage.
OPTIONS
Options for the config command
To Next Page
Loading...
