VCAUTOHUNT
NAME
vcautohunt – this command is to configure the vcautohunt feature.
SYNOPSIS
Usage:
vcAutoHunt help
vcAutoHunt show
vcAutoHunt send
vcAutoHunt save
service(hex) :
bit0: PPPoE/VC (1),bit1:PPPoE/LLC (2) ,bit2:PPPoA/VC (4),
bit3: PPPoA/LLC (8), bit4:Enet/VC (10), bit5 :Enet/LLC (20)
vcAutoHunt add
<PvcId 0~1> <RuleId 0~6> <vpi> <vci> <service(hex)>
vcAutoHunt remove
<PvcId 0~1> <RuleId 0~6>
vcAutoHunt set
<param> <arg1> <arg2>.. - set a provisionable parameter
List of vcAutoHunt set params and args:
active
<1|0: On|Off> - To activate hunting mechanism when system reboot
again
<1|0: On|Off> - to hunt whenever ADSL line up
debug
<1|0: On|Off> - Turn on Debug flag to see the debug message
sendPeriod
<seconds> - The period of sending test pattern
testExpire
<seconds> - the expire time for each case
DESCRIPTION
This command is to configure vcAutoHunt feature . belong to Broadcom linux command line utility that
controls the SPU driver will be starts and stops the SPU subsystem.
OPTIONS
None
To Next Page
Loading...
