pid... Specify the list of processes that kill should sigal.
-signal given as a signal name or number.
-l List all signal names and numbers.
EXAMPLES
° Terminate the process with pid 120
> kill 120
° Send KILL signal to the process with pid 120
> kill –SIGKILL 120
° List all signal names and numbers
> kill -l
LAN
NAME
lan – allow a user to configure the IP layer for the LAN interfaces
SYNOPSIS
lan config
[
--ipaddr <primary|secondary> <I
P
address> <subnet mask>]
[--dhcpserver <enable|disable>]
[--dhcpclient <enable|disable>]
lan delete
–ipaddr <primary|secondary>
lan show [<primary|secondary>]
lan --help
DESCRIPTION
Lan is used to configure the IP layer data for the primary and secondary LAN interfaces. A LAN interface
is a logic interface toward IP stack from the Bridge module. Both primary and secondary LAN interfaces
share the same MAC address from the physical Ethernet port. This utility can:
° Configure the IP address and subnet mask for the primary LAN interface. It Can be either a private or a
public IP address.
° Configure the IP address and subnet mask for the secondary LAN interface. NAT is not supported on the
secondary LAN interface. Only public IP address is allowed.
To Next Page
Loading...
