Usage: wlctl pkt_filter_clear_stats <id>
pkt_filter_enable
Enable/disable a packet filter.
Usage: wlctl pkt_filter_enable <id> <0|1>
pkt_filter_list
List installed packet filters.
Usage: wlctl pkt_filter_list [val]
val: 0 (disabled filters) 1 (enabled filters)
pkt_filter_mode
Set packet filter match action.
Usage: wlctl pkt_filter_mode <value>
value: 1 - Forward packet on match, discard on non-match (default).
0 - Discard packet on match, forward on non-match.
pkt_filter_delete
Uninstall a packet filter.
Usage: wlctl pkt_filter_delete <id>
pkt_filter_stats
Retrieve packet filter statistic counter values.
Usage: wlctl pkt_filter_stats <id>
seq_start
Initiates command batching sequence. Subsequent IOCTLs will be queued until
seq_stop is received.
seq_stop
Defines the end of command batching sequence. Queued IOCTLs will be executed.
seq_delay
Driver should spin for the indicated amount of time.
It is only valid within the context of batched commands.
seq_error_index
Used to retrieve the index (starting at 1) of the command that failed within a batch
bmac_reboot
Reboot BMAC
txmcsset
get Transmit MCS rateset for 11N device
rxmcsset
To Next Page
Loading...
