Makes the interface <device> a port of the bridge <bridge>. This
means that all frames received on <device> will be processed as if destined for the bridge. Also, when
sending frames on <bridge>, <device> will be considered as a potential output interface.
delif <bridge> <device>
Detaches the interface <device> from the bridge <bridge>.
showmacs <bridge>
Shows a list of learned MAC addresses for this bridge.
showstp <bridge>
Shows the STP (Spanning Tree Protocol) status of this bridge.
setageing <bridge> <time>
Sets the MAC address ageing time, in seconds. After <time> seconds of not having seen a frame
coming from a certain address, the bridge will time out (delete) that address from the Forwarding
DataBase (fdb).
setbridgeprio <bridge> <priority>
Sets
the
bridge's
priority
to
<priority>.
The
priorit
y
value
is
an
unsi
gne
d
16
-bit
quantity
(a
numb
er
between 0 and 65535), and has no dimension. Lower priority values are 'better'. The bridge with the
lowest priority will be elected 'root bridge'.
setfd <bridge> <time>
Sets the bridge's 'bridge forward delay' to <time> seconds.
setgcint <bridge> <time>
Sets the garbage collectioninterval for the bridge <bridge> to <time> seconds. This means that the
bridge will check the forwarding database for timed out entries every <time> seconds.
sethello <bridge> <time>
Sets the bridge's 'bridge hello time' to <time> seconds.
setmaxage <bridge> <time>
Sets the bridge's 'maximum message age' to <time> seconds.
setpathcost <bridge> <port> <cost>
Sets the port cost of the port <port> to <cost>. This is a dimensionless metric.
setportprio <bridge> <port> <prio>
Sets the port
<port>'
s p
riority to <priorit
y>
.
The priority value is an
unsigned 8
-bit quantity (a number
between 0 and 255), and has no dimension. This metric is used in the designated port and root port
selection algorithms.
setportsnooping <bridge> <port> <addr>
Adds
an
entry
for
a
port
<port>
in
the
port
snoop
ing
table
of
the
b
ridge
<bridge>.
The
format
of
the
To Next Page
Loading...
