VCC Con. Service Interface Proto. IGMP Status IP
ID Name Name address
N/A 0 ipoe_0_0_1 ptm0 IPoE Disable Connected 10.6.37.15
Wan show (ATM):
All services associated with atm2 is activated.
VCC Con. Service Interface Proto. IGMP Status IP
ID Name Name address
0.0.35 0 pppoe_0_0_35 ppp0 PPPoE Disable Connected 10.6.33.155
0.0.36 0 pppoa_0_0_36 pppoa1 PPPoA Disable Connected 10.6.33.156
0.2.35 0 ipoe_0_2_35 atm2 IPoE Disable Connected 10.6.33.197
° Display help usage for bridge/ipoe/pppoe/ipoa/pppoa
wan –help bridge
Usage: wan config <port.vpi.vci>
[--protocol <bridge|pppoe|pppoa|mer|ipoa>] [--encap <llc|vcmux>]
[--state <enable|disable>] [--service <servicename>]
wan delete <port.vpi.vci>
wan show [<port.vpi.vci>]
wan --help <bridge|pppoe|pppoa|ipoe|ipoa>
wan –help ipoe
Usage:
wan add service <L2interfacename> --protocol ipoe
[--firewall <enable|disable>] [--nat <enable|disable>]
[--igmp <enable|disable>]
[--ipaddr <wanipaddress> <wansubnetmask]
[--dhcpclient <enable|disable>]
[--gatewayifname <L2interfacename>] [--dnsifname <L2interfacename>]
wan delete interface atm <port.vpi.vci>
wan delete interface ptm <port> --priority <normal|high|both>
wan delete service L3IfName
wan show interface
wan show [<port.vpi.vci>]
wan --help <bridge|pppoe|pppoa|ipoe|ipoa>>
wan –help pppoe
Usage:
wan add service <L2interfacename> --protocol pppoe
[--firewall <enable|disable>] [--nat <enable|disable>]
[--igmp <enable|disable>]
[--username <username> --password <password>]
[--pppidletimeout <timeout>] [--pppipextension <disable|enable>]
[--gatewayifname <pppinterfacename>] [--dnsifname <pppinterfacename>]
wan delete interface atm <port.vpi.vci>
wan delete interface ptm <port> --priority <normal|high|both>