° display status and information of XDSL driver and connection
° display statistics for XDSL driver and connection
All information is displayed to stdout. A program or shell script that calls this utility can redirect stdout
COMMANDS
start:
Starts the Broadcom XDSL driver. This command calls BcmXdsl_Initialize to initialize the driver and
BcmXdsl_ConnectionStart to start XDSL PHY connection if [--up] is specified. This command takes
parameters that can specify various connection modes. These parameters are the same as in “configure”
command.
stop:
Stops XDSL connection and Broadcom XDSL driver. This command calls BcmXdsl_Uninitialize.
configure :
Configures XDSL connection parameters. These command takes the same parameters as “start”
command except for [--up] . This command will cause XDSL PHY to retrain.
connection :
Controls XDSL connection modes, such as up and down and several special test modes. This
command can also be used to specify tone selection for upstream and downstream..
bert :
Controls XDSL bit error rate test (BERT). This command can start/stop
the BERT test and monitor its results.
afelb :
Starts, sets control parameters such as test time, signal type for AFE loopback test.
qlnmntr :
Starts, sets control parameters such as total monitor time,reporting frequency for QLN monitoring test
mode.
inm :
To configure inm parameters and Start inm, Stop monitoring, and show inm results
info :
Display information about XDSL driver and PHY status.
diag :
Log statuses locally. It is useful when DslDiags is not available
snrclamp :
To Next Page
Loading...
