ZyXEL Communications VMG1312 - Page 7

7
ZyXEL Confidential
www.zyxel.com
To show the “NonLinearityFlag”,“NumberOfAffectedBins” and “Echo-to-Noise Ratio (ENR)”.
--version:
Show current version.
--help:
Show the adsl support commands.
OPTIONS
Options for the start and configure commands :
adsl start [--up] [--mod <a|d|l|t|2|p|e|m|v>] [--lpair <(i)nner|(o)uter>]
[--trellis <on|off>] [--snr <snrQ4>] [--bitswap <on|off>][--sesdrop <on|off>][--sra
<on|off>][--CoMinMgn<on|off>][--i24k<on|off>][--phyReXmt <0xBitMap-UsDs>][--TpsTc
<0xBitMap-AvPvAaPa>][--profile <0x00 – 0x7F> | <”8a |8b |8c |8d |12a |12b |17a |30a”>] [--us0
<on|off>][--forceJ43 <on|off>][--toggleJ43B43 <on|off>]
or for AnnexC:
[--bm <(D)BM|(F)BM>] [--ccw]
adsl configure [--mod <a|d|l|t|2|p|e|m>] [--lpair <(i)nner|(o)uter>]
[--trellis <on|off>] [--snr <snrQ4>] [--bitswap <on|off>]
or for AnnexC:
[--bm <(D)BM|(F)BM>] [--ccw]
--up :
Will call BcmAdsl_ConnectionStart to start ADSL PHY connection
--mod <a|d|l|t|2|p|e|m|v> :
a – all modulations allowed.
d – G.DMT enabled
l – G.Lite enabled
t – T1.413 enabled
2 – ADSL2 (G.992.3) enabled
p – ADSL2+ (G.992.5) enabled
e – Reach extended ADSL (AnnexL) enabled
m – Double upstream (Annex M) enabled
v – VDSL2 enabled
More than one mode letter can be given to enable several modes.
--lpair <(i)nner|(o)uter>:
(i)nner –inner loop pair is used
(o)uter – outer loop pair is used
--trellis <on|off> :
Enabled or disables trellis coding