‧ Restore to a known good default state.
out
Marks the adapter down, but does not reset the hardware (disabled).
Syntax:
> wlctl out
On dual-band cards, the card must be band-locked before use.
restart
Restarts the driver.
Syntax:
> wlctl restart
The driver must already be down (you should do a wlctl down before restarting the driver). Otherwise,
the following message is returned:
> wlctl restart
radio
Turns the radio on or off using a software switch.
Syntax:
> wlctl radio on/off
Typing wlctl radio returns the current state of the radio. For example, 0x0000 when ON or 0x0005
when OFF, and so on.
eventing
Set/get the 128-bit hexadecimal filter bitmask for MAC event reporting up to application layer.
event_msgs
Sets/gets the 128-bit hexadecimal filter bit mask for MAC event reporting (through packet
indications).
Default: 0
Takes a 128-bit vector, which selectively enables or disables the reporting of MAC events through the
packet data path. For example, setting bit locations 0 and 3 would enable the reporting of
WLC_E_SET_SSID and WLC_E_AUTH event
messages, and so on.
Syntax:
To Next Page
Loading...
