For a specific built-in country definition: wlctl country <built-in> [<advertised-country>]
Where <built-in> is a country country code followed by '/' and regulatory revision number.
For example, "US/3".
And where <advertised-country> is either a long name or country code from ISO 3166.
If <advertised-country> is omitted, it will be the same as the built-in country code.
Use 'wlctl country list [band(a or b)]' for the list of supported countries
country_ie_override
To set/get country ie
autocountry_default
Select Country Code for use with Auto Contry Discovery
join
Join a specified network SSID.
Usage: join <ssid> [key <0-3>:xxxxx] [imode bss|ibss] [amode
open|shared|openshared|wpa|wpapsk|wpa2|wpa2psk|wpanone] [options]
Options:
-b MAC, --bssid=MAC BSSID (xx:xx:xx:xx:xx:xx) to scan and join
-c CL, --chanspecs=CL chanspecs (comma or space separated list)
ssid
Set or get a configuration's SSID.
wlctl ssid [-C num]|[--cfg=num] [<ssid>]
If the configuration index 'num' is not given, configuraion #0 is assumed and
setting will initiate an assoication attempt if in infrastructure mode,
or join/creation of an IBSS if in IBSS mode,
or creation of a BSS if in AP mode.
mac
Set or get the list of source MAC address matches.
wlctl mac xx:xx:xx:xx:xx:xx [xx:xx:xx:xx:xx:xx ...]
To Clear the list: wlctl mac none
macmode
Set the mode of the MAC list.
0 - Disable MAC address matching.
1 - Deny association to stations on the MAC list.
2 - Allow association to stations on the MAC list.
wds
Set or get the list of WDS member MAC addresses.
Set using a space separated list of MAC addresses.
wlctl wds xx:xx:xx:xx:xx:xx [xx:xx:xx:xx:xx:xx ...]
To Next Page
Loading...
