Chapter 7 Wireless
VMG3925-B10C/B30C User’s Guide
108
Figure 37 Network Setting > Wireless > MAC Authentication
The following table describes the labels in this screen.
7.5 The WPS Screen
Use this screen to configure WiFi Protected Setup (WPS) on your VMG.
Table 19 Network Setting > Wireless > Authentication
LABEL DESCRIPTION
General
SSID Select the SSID for which you want to configure MAC filter settings.
MAC Restrict
Mode
Define the filter action for the list of MAC addresses in the MAC address list.
Select Disable to turn off MAC filtering.
Select Deny to block access to the VMG. MAC addresses not listed will be allowed to access
the VMG.
Select Allow to permit access to the VMG. MAC addresses not listed will be denied access to
the VMG.
MAC address List
Add new MAC
address
Click this if you want to add a new MAC address entry to the MAC filter list below. This button is
not configurable when you select Disable in the MAC Restrict Mode field.
Enter the MAC addresses of the wireless devices that are allowed or denied access to the
VMG. Enter the MAC addresses in a valid MAC address format, that is, six hexadecimal
character pairs, for example, 12:34:56:78:9a:bc.
# This is the index number of the entry.
MAC Address This is the MAC addresses of the wireless devices that are allowed or denied access to the
VMG.
Modify Click the Edit icon to change the MAC address.
Click the Delete icon to remove the entry.
Apply Click Apply to save your changes.
Cancel Click Cancel to restore your previously saved settings.
To Next Page
Loading...
