Chapter 4 Tutorials
VMG3925-B10C/B30C User’s Guide
40
Thomas can now use the WPS feature to establish a wireless connection between his notebook and the
VMG (see Section 4.3.2 on page 40). He can also use the notebook’s wireless client to search for the
VMG (see Section 4.3.3 on page 43).
4.3.2 Using WPS
This section shows you how to set up a wireless network using WPS. It uses the VMG as the AP and a WPS-
enabled Android 4.4.2 smartphone as the wireless client.
There are two WPS methods to set up the wireless client settings:
• Push Button Configuration (PBC) - simply press a button. This is the easier of the two methods.
• PIN Configuration - configure a Personal Identification Number (PIN) on the VMG. A wireless client
must also use the same PIN in order to download the wireless network settings from the VMG.
Push Button Configuration (PBC)
1 Make sure that your VMG is turned on and your Android 4.42 smartphone is within the cover range of the
wireless signal.
2 WPS is enabled by default on the VMG. If not, log into VMG’s Web Configurator and turn it on in the
Network Setting > Wireless > WPS screen. You can either press the WPS button on the VMG’s panel or
press the WPS button in the Network Setting > Wireless > WPS screen
3 Go to your phone settings and turn on Wi-Fi. Open the Wi-Fi networks list and tap WPS Push Button or the
WPS icon ( ).
Note: It doesn’t matter which button is pressed first. You must press the second button within
two minutes of pressing the first one.
The VMG sends the proper configuration settings to the wireless client. This may take up to two minutes.
The wireless client is then able to communicate with the VMG securely.
The following figure shows you an example of how to set up a wireless network and its security by
pressing a button on both VMG and wireless client (the Android 4.4.2 phone in this example).
To Next Page
Loading...
