Chapter 8 Home Networking
VMG3925-B10C/B30C User’s Guide
135
If you click Static DHCP Configuration in the Static DHCP screen or the Edit icon next to a static DHCP
entry, the following screen displays.
Figure 53 Static DHCP: Static DHCP Configuration/Edit
The following table describes the labels in this screen.
IP Address This field displays the IP address relative to the # field listed above.
Modify Click the Edit icon to have the IP address field editable and change it.
Click the Delete icon to delete a static DHCP entry. A window displays asking you to confirm
that you want to delete the selected entry.
Table 29 Static DHCP: Static DHCP Configuration/Edit
LABEL DESCRIPTION
Active Select Enable to activate the connection between the client and the VMG.
Group Name Select the interface group name for which you want to configure static DHCP settings. See
Chapter 15 on page 198 for how to create a new interface group.
IP Type This field displays IPv4 for the type of the DHCP IP address. At the time of writing, it is not
allowed to select other type.
Select Device Info Select a device or computer from the drop-down list or select Manual Input to manually enter
a device’s MAC address and IP address in the following fields.
MAC Address If you select Manual Input, enter the MAC address of a computer on your LAN.
IP Address If you select Manual Input, enter the IP address that you want to assign to the computer on
your LAN with the MAC address that you will also specify.
OK
Click OK to save your changes.
Cancel Click Cancel to exit this screen without saving.
Table 28 Network Setting > Home Networking > Static DHCP
LABEL DESCRIPTION
To Next Page
Loading...
