Chapter 4 Multy M1 Wizard
Multy WiFi System User’s Guide
115
Note: You may need to turn off your network firewall if access to the Internet from the Multy M1
is blocked. Turn on your network firewall after the configuration is completed.
You need to connect to the Internet to access your Multy M1. See Section 4.2 on page
113 if you cannot connect to the Internet.
3 Enter 1-128 single-byte printablecharacters but not "''<>^$& as your 2.4G/5G WiFi Name and WiFi
Password. Select the check box Keep 2.4G & 5G name the same if you want to use the same name for
your 2.4G and 5G WiFi.
4 The following screen shows if you have set up your WiFi name and password successfully. Click Next to
go to the next step in the wizard.
To Next Page
Loading...
