Chapter 7 Multy M1 Web Configurator Tutorials
Multy WiFi System User’s Guide
142
3 After you click Apply, the Multy M1 web configurator will go to the Parental Control > Device > Device
Detail screen. Make sure the parental control profile you created has been applied to the specific
client.
Disable a Parental Control Profile
You can disable the parental control profiles to stop the Multy M1 from blocking the connected clients
during the time you set.
Suppose you no longer need to block a specific client from accessing the Internet during the time for
studying. Go to Parental Control > Profile and find the Study profile. Slide the switch to the left ( ) to
disable the profile.
7.7 Configure a Firewall Rule
This section shows you how to enable the firewall to protect your network from malicious attacks from
the Internet.
7.7.1 Enable Respond to Ping and Firewall
Enable Respond to Ping to activate Internet Control Message Protocol (ICMP) on the Multy M1. Enable
Firewall to protect the Multy M1 from DoS attacks.
ICMP
Internet Control Message Protocol (ICMP) is a message control and error-reporting protocol between a
host server and a gateway to the Internet. Enable this to have the Multy M1 respond only to incoming
Ping requests from the specified interface. Attackers can ping the devices to find their locations through
their responds then attack them. If you set the Multy M1 to not respond to Ping requests from the WAN,
To Next Page
Loading...
