ZyXEL Communications WSR30 - CHAPTER 5 Multy M1 Web Configurator; 5.1 Overview; 5.2 Accessing the Web Configurator

Multy WiFi System User’s Guide
120
CHAPTER 5
Multy M1 Web Configurator
5.1 Overview
This chapter describes how to access the Multy M1 Web Configurator and provides an overview of its
screens.
The Web Configurator is an HTML-based management interface that allows easy system setup and
management via Internet browser. Use a browser that supports HTML5, such Mozilla Firefox, or Google
Chrome. The recommended screen resolution is 1024 by 768 pixels.
In order to use the Web Configurator you need to allow:
• Web browser pop-up windows from your device.
• JavaScript (enabled by default).
• Java permissions (enabled by default).
5.2 Accessing the Web Configurator
1 Make sure your Multy M1 hardware is properly connected (refer to the Quick Start Guide).
2 Launch your web browser.
3 If the Multy M1 is in Standard Mode (the default mode), enter "http://zyxelwifi.com or 192.168.212.1" in
the browser’s address bar.
If the Multy M1 is in Bridge Mode, enter “http:// (DHCP-assigned IP)” in the browser’s address bar.
4 On the displayed login screen, log in using your myZyxelCloud username and password or the local
password.
Note: If this is the first time you are accessing the web configurator or if the device has been
reset, you must complete the setup wizard, see Chapter 4 on page 113.
Note: For setting and changing the local password, see Section 7.9 on page 147.