Chapter 5 Multy M1 Web Configurator
Multy WiFi System User’s Guide
125
5.3.2 Bridge Mode Navigation Panel
Figure 38 Navigation Panel (Bridge Mode)
The following table describes the submenus.
Table 9 Settings > System > Status (Bridge Mode)
LINK TAB FUNCTION
Overview Use this screen to:
• View read-only information about your Multy M1
• Configure WiFi settings
•
Diagnose Advanced
Speed Test
Use this screen to check the speed of the connection between your Multy M1
and the broadband modem/router.
Speed Test
History
Use this screen to view a summary of previously run speed tests.
Mesh My Mesh Use this screen to view Mesh network information.
Settings
WiFi Main WiFi Use this screen to enable the wireless LAN and configure wireless LAN and
wireless security settings.
WPS Use this screen to configure WPS.
Scheduling Use this screen to schedule the times the Wireless LAN is enabled.
LAN LAN IP Use this screen to configure the Multy M1’s LAN IP address and subnet mask.
Use this screen to configure the Multy M1’s DNS server.
System Status Use this screen to view the basic information of the Multy M1
General
Setting
Use this screen to change password or to set the timeout period of the
management session.
Remote
Access
Use this screen to configure remote assistant.
Maintenance Use this screen to upgrade firmware, restart the Multy M1 without turning the
power off or reset the Multy M1 to factory default settings.
Operating
Mode
Use this screen to select whether your device acts as a router, or a bridge.
Logs Use this screen to view the list of activities recorded by your Multy M1.
To Next Page
Loading...
