Chapter 6 Multy M1 Modes
Multy WiFi System User’s Guide
131
6.9 Bridge Mode Status Screen
Click Settings > System > Status to open the status screen.
Figure 44 Settings > System > Status (Bridge Mode)
The following table describes the labels shown on the Status screen.
Table 11 Settings > System > Status (Bridge Mode)
LABEL DESCRIPTION
System
Model Name This is the model name of your device.
Firmware Version This is the firmware version.
System Operation Mode This is the device mode to which the Multy M1 is set, see Section 7.11 on page 150
for more information.
Enable IPv4 Firewall This shows if the IPv4 firewall is enabled on the Multy M1.
Enable IPv6 Simple Security This shows if the IPv6 firewall is enabled on the Multy M1.
System Uptime This is the total time the Multy M1 has been on.
LAN Information
MAC Address This shows the LAN Ethernet adapter MAC Address of your device.
IP Address This shows the LAN port’s IP address.
IP Subnet Mask This shows the LAN port’s subnet mask.
DHCP Server This shows the LAN port’s DHCP role - Enable or Disable.
IPv6 Address This shows the current IPv6 address of the Multy M1 in the LAN.
To Next Page
Loading...
