Chapter 2 Hardware
Multy WiFi System User’s Guide
26
WSQ60 / WSQ50 / WSQ20:
1 Make sure the LED light on the top panel is not blinking white.
2 Press the reset button for at least 5 seconds or until the LED starts to blink red.
WSR30:
Press the reset button for at least 5 seconds or until the LED starts to blink amber.
WSM20:
Press the reset button for at least 5 seconds or until the LED starts to blink yellow.
2.5 LED On/Off Switch
WSM20:
Press the LED On/Off switch to turn on or off LED lights.
Figure 26 WSM20 LED On/Off Switch
To Next Page
Loading...
