Chapter 7 Multy M1 Web Configurator Tutorials
Multy WiFi System User’s Guide
144
1 Set Rule Status to Enable and Actions to Drop.
2 Click Add Rule and enter the service name, destination IP address and MAC address as given above.
3 Click Apply to save your changes.
Block Packets from a Specified IP Address
The example below shows you how to block an advertisement website from sending packets to all
clients connected to the Multy M1. The following example uses the parameters below to configure the
access control rule.
1 Set Rule Status to Enable and Actions to Drop.
2 Click Add Rule and enter the service name and source IP address as given above.
Table 16 Access Control Rule Example Parameters
SERVICE NAME SOURCE IP ADDRESS ACTIONS
Ads Website 1.1.1.1 Drop
To Next Page
Loading...
