Chapter 4 App Tutorials
WX Series User’s Guide
49
7 The POWER and Link LED on the WX Device-2 turns steady green if the pairing process is successful. You
can also check the result on the app screen.
8 Click Done to finish the pairing process. The WX Device-1 (the controller) will undergo an automatic
configuration after a Mesh network is established. (See Section 1.2 on page 15 for more information).
Check the status of your WiFi Mesh network on the Home screen.
Successful p airing
9 The POWER LED shows if the WX Device-2 is ready to join the WiFi network. The LINK LED shows the WiFi link
quality. See Section Table 13 on page 49 for more information on LED behaviors.
10 Now you can connect your WiFi clients to your WiFi Mesh network. To do this, note the SSID and WiFi key
printed on the side label of the WX Device-1 using this SSID.
Table 13 LED Table (for WX Device-2)
LED COLOR STATUS DESCRIPTION
POWER Green On Power is on or the MPro Mesh configuration process is done.
Blinking The WX Device-2 is starting up or under the MPro Mesh configuration process.
Red On The WX Device-2 detects a system error.
Blinking The WX Device-2 is upgrading firmware
Link (with a
WiFi
connection)
Green On The WiFi connection to the WX Device-1 is good.
Red On The signal is too weak. Move the WX Device-2 closer to the WX Device-1.
To Next Page
Loading...
