Chapter 27 Switch Setup
XMG1915 Series User’s Guide
167
Figure 117 SYSTEM > Switch Setup
The following table describes the labels in this screen.
Table 81 SYSTEM > Switch Setup
LABEL DESCRIPTION
VLAN Type Choose 802.1Q or Port Based. The SWITCHING > VLAN link and its sub-links only appears when
you choose 802.1Q VLAN type in this screen.
MAC Address Learning
MAC address learning reduces outgoing traffic broadcasts. For MAC address learning to occur on a port, the port
must be active.
Aging Time Enter a time from 10 to 1000000 seconds. This is how long all dynamically learned MAC
addresses remain in the MAC address table before they age out (and must be relearned).
ARP Aging Time
Aging Time Enter a time from 60 to 1000000 seconds. This is how long dynamically learned ARP entries
remain in the ARP table before they age out (and must be relearned). The setting here applies
to ARP entries which are newly added in the ARP table after you click Apply.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
To Next Page
Loading...
